Have questions about mounting the SkamoWall system?
Contact us to clarify mounting steps, requirements, and practical considerations
Here you will find answers to questions about mounting SkamoWall
- Wedge spacers
- Pencil
- Drill
- Hand saw
- Utility knife
- Paint roller
- Brick trowel
- Sandpaper
- Safety glasses
- Bucket
- Trowel
- Notched trowel
- Carpenter's ruler
- Spirit level
Either 5mm of air or 5mm with an inorganic elastic material.
Skamol Mesh should only be used in cases where the walls are subject to vibrations, such as railroad tracks.
Tar, paint residue and other organic material must be removed.
Unevenness must not exceed 10mm.
Unevenness must not exceed 10mm.
Multiple layers of Skamol Lime Mortar can be applied in thicknesses of 10mm to even out the wall surface. Allow each layer to harden before applying a new layer of adhesive.
Ordinary hand tools should be used:
No special equipment is required, but it is recommended to check the safety data sheets for instructions.
No, but dust must be removed. Water or Skamol Primer can be used for this.
Most often the best result is achieved by layering several thin layers on top of each other.
Remember to only use Skamol Lime Mortar or Skamol Smooth Plaster.
Yes.
Both sides of SkamoWall Board must be primed with Skamol Primer.
No.
There is no difference in the function of the two sides of the SkamoWall Board.
Therefore, it does not matter which side of the SkamoWall Board is mounted facing the room.